Greenie512

This page is to be developed further .... but will include

24/06/2007 ... I had a bit of spare time this morning so ... this was a “first run” with a bit of scrap MDF.

Flush Mitre Joints

I saw this technique on another site? but before I got some decent power tools accurate 45°  cuts where out of the question for me.

	I love my Jet table saw but it is mechanical and how accurate can the adjustments be? No problem; my little Wixey digital angle meter solves this!
	Line up panels, tight and tape together with masking tape. Yep, burn marks shouldn’t be there. If this was for real I’d run them over a 45° router bit to clean that error out.
	Apply glue, wrap and tape tight. Vola, perfect box You may have spotted? the sides are only 100 mm wide, we’ll see how easy this is on a larger box later!!!